• The difference between LFT and other materials

    The difference between LFT and other materials

    1. Comparison of LFT and short glass fiber reinforced plastics Compared with traditional short glass fiber reinforced plastics, the LFT technology with special screw, die and cutter design and sizing agent formula can obtain pellets of more than 12mm. The fiber length is equivalent to the pellet len... read more

    Jan 07,2022 News
  • Introduction of LFT materials

    Introduction of LFT materials

    LFT, long fiber reinforced thermoplastic material, English is Long Fiber reinforced Thermoplastics, is compared with ordinary fiber reinforced thermoplastic materials, under normal circumstances, the fiber length in fiber reinforced thermoplastic materials is less than 1 mm, while in LFT, The length... read more

    Dec 29,2021 News
  • Introduction to the concept of bmc mold forming processing

    Introduction to the concept of bmc mold forming processing

    BMC material is the abbreviation of Bulk (Dough) moldingcompounds, that is, bulk plastic. China is often referred to as unsaturated polyester blob plastic. The key raw materials are GF (short-cut glass fiber), UP (polyurethane resin), MD (filler calcium bicarbonate) and various additives fully mixed... read more

    Dec 24,2021 News
  • Flash treatment in the production process of SMC and BMC molds

    Flash treatment in the production process of SMC and BMC molds

    In the production process of SMC and BMC mold products, there is a problem that is very important, but it is also easy to handle, that is, flash processing. Since SMC is a sheet molding compound, a mixed polymer resin, the raw materials are full of glass fibers, minerals, and fillers. The BMC materi... read more

    Dec 17,2021 News
  • SMC FRP molds need to pay attention to details

    SMC FRP molds need to pay attention to details

    1. The silicone rubber material is in a fluid state before use, with good fluidity and filling properties. After being formulated, a rubber elastomer is formed through cross-linking reaction, which can have greater elastic deformation, and the water in the original mold has no effect on its cross-li... read more

    Dec 10,2021 News
Contact Us